Filter Product By
Slide and select filter/s
Filtered by
Categories
Loading
Load more
Loading
Viewed products
One board for three architectures
dsPIC33, PIC24 & PIC32
For the first time we combined the power of three separate boards in one ultimate board for high performance Microchip MCUs. Developers now have the new scalability like never before.
Everything is already here
mikroProg™ on board
Powerful on-board mikroProg™ programmer and In-Circuit debugger supports over 101 microcontrollers. It features fast enhanced programming and rich set of debugging instructions.
Ready for all kinds of development
Multimedia peripherals
TFT 320x240 with touch panel, stereo audio codec, USB device and host, navigation switch and microSD card slot make a perfect set of peripherals for multimedia development.
For easier connections
mikroBUS™ support
This innovative new socket allows you to use dozens of Click accessory boards with almost no hardware adjustments. Adding new functionality to your device was never so easy.
MIKROE-1205$249.00
ATA6563 Click is a compact add-on board that provides an interface between a controller area network (CAN) protocol and the physical two-wire CAN bus. This board features the ATA6563, a high-speed CAN transceiver with standby mode from Microchip. The transceiver is designed for high speeds of up to 5Mbps and provides differential transmit and receive capabilities to a CAN protocol controller. It has ideal passive behavior to the CAN bus when the supply voltage is off. This Click board™ makes the perfect solution for the development of classical CAN and CAN FD networks in automotive, industrial, aerospace, medical, and consumer applications.
ATA6563 Click is supported by a mikroSDK compliant library, which includes functions that simplify software development. This Click board™ comes as a fully tested product, ready to be used on a system equipped with the mikroBUS™ socket.
MIKROE-2334$20.00
MCP2518FD Click is a compact add-on board representing a complete CAN solution used as a control node in a CAN network. This board features the MCP2518FD, an external CAN FD controller with an SPI interface, and a high-speed CAN transceiver, the ATA6563, both from Microchip. The ATA6563, a low-level physical layer IC (PHY), provides a physical connection with the CAN bus itself, while the CAN controller MCP2518FD represents an interface between the MCU and the PHY. It features three operating modes with dedicated fail-safe features, remote wake-up via CAN, and ideally passive behavior when powered off on the CAN bus. This Click board™ is suitable for developing a wide range of automotive diagnostic applications, even on MCUs that do not natively support CAN interface.
MCP2518FD Click is supported by a mikroSDK compliant library, which includes functions that simplify software development. This Click board™ comes as a fully tested product, ready to be used on a system equipped with the mikroBUS™ socket.
MIKROE-3060$45.00
MCP2542 click is the CAN bus transceiver, which allows TTL/CMOS level signals typically found on MCUs, to be used for the communication via the CAN bus, which uses the higher voltage levels and differential signals. In addition, this Click board™ protects the sensitive MCU part of the device from excessive voltage spikes and electrostatic discharges (ESD), typically observed in automotive systems, where the CAN communication is extensively used. This Click board™ uses the MCP2542WFD, a CAN FD transceiver, which offers robust CAN bus interface, with ESD protection up to ±13 kV, permanent dominant detection on TXD and CAN bus, battery short circuit and electrical transients suppression on the CAN bus, thermal protection, and more.
MIKROE-2299$20.00